How to Swingweight a Set

March 23, 2011

This particular article will be helpful for LG, so I decided to go ahead and build up a post about this.

I recently swingweighted my iron set–KZG ZO blades. The shafts were shorter than I was used to, so I decided I wanted them to play at a higher swingweight in order to make up the lost leverage.

First things first, get your supplies in order:

1. Two-part epoxy – depends on size, but enough for this job is $5 or so.
2. ferrules – make sure you get the right size for your irons, which can range from .335 to .370; I bought mine on ebay, and you can really spend any amount of money you want to on them. Approximately $5, we’ll say. Search on ebay for “ferrule .XXX” where .XXX is the tip diameter you need.
3. Swingweights. This part is a little more difficult, and can be expensive. A full set of swingweights isn’t a good idea. I would recommend you figure out what you need first and then go online and buy them. I got brass weights on ebay from a great seller todd1186 (he’ll combine shipping if you just ask, see
4. A swingweight scale. These can be anywhere from $20 used up to hundreds. If you’d prefer not to use one, you can always take them to your local golfsmith or edwin watts store and ask them to spec it out for you. If they’re not busy, they might actually do it, especially if you’re telling them you’re considering having them swingweighted.
5. Acetone. $4 at home depot
6. A kitchen/postal scale. $4-$6 on ebay
7. Lead tape (or other weight)

Now, that’s about it for supplies–sans paper towels, newspaper, and other cheap stuff.

Once you know what your current swingweight is, you can decide what you want it to go to. Typically, you will want to increase swingweight because OEM sets are typically a little light on the scale. Typical sets will run D0 or lighter. Most pros like Read the rest of this entry »